« Back to all recent discussions

No possibility to configure NAS

ChristophoroChristophoro Posts: 2  Junior Member
edited June 24 in Discussions
Hello,
I'm trying to configure my NAS326. I have to harddisks connected as RAID1 disk.
When I'm logging in using browser (any browser, few computers) - I can see no icons to set anything.
I can see them - when I pull disks out :( I've upgraded firmware to newest version, but it didn't help.
But I can see and connect network folders... I have no idea what shoud I do. Did anyone faced the problem as well?

#NAS_June_2020


Comments

  • TY9527TY9527 Posts: 67  Warrior Member
    When I'm logging in using browser (any browser, few computers) - I can see no icons to set anything.
    No icons on the page? have you tried clean browser cache? or using incognito mode?

    I can see them - when I pull disks out  I've upgraded firmware to newest version, but it didn't help.
    How about put in another new disk? maybe something wrong on the old ones.
  • ChristophoroChristophoro Posts: 2  Junior Member
    Hi,
    I've tryied on new installed browser as well - Explorer, Chrome, Firefox.
    I can see icons when I take disks out... It's quite hard to find two 2TB disks and replace them... there is a lot of data... But raid and disks are healthy - this is information from NAS... (I can put icon on the bottom line of panel). Icons on the top  in header - doesn't work as well :(
  • MijzelfMijzelf Posts: 1,205  Heroic Warrior Member
    If it does work when the disks are out, then you might have a misbehaving package. In that case a factory reset might do the trick.
Sign In or Register to comment.